edge joint
英 [edʒ dʒɔɪnt]
美 [edʒ dʒɔɪnt]
边缘接头，端接接头
双语例句
- The first requirement of a good edge joint is that the two mating surfaces must fit together perfectly.
做好边的连接的第一个要求就是对接的两条边必须能完美地拼合。 - To do this, carefully go along the edge vertically with respect to the joint seal with a spatula.
为此，用抹刀沿接缝密封件边缘垂直切割。 - Mechanical Model and Boundary Condition From the Edge Joint of Giant Transformer Fuel Tank
大型变压器油箱箱沿力学模型和边界条件模拟的研究 - A cut or groove along or near the edge of a piece of wood that allows another piece to fit into it to form a joint.
槽口沿着一块木头或在其顶端附近的切口或槽口，可让另一块木头接合形成榫头。 - The resistance curves were measured with the standard three point bending specimens and the double edge notched tension specimens at different mis-matching welded joint.
对管线用钢焊接接头，测试了标准三点弯曲试样、同种接头及不同匹配状态的双边裂纹拉伸试样的阻力曲线。 - Widely applies in the electric wire edge joint, electric wire nose processing;
广泛应用于电线的边接、电线端部处理； - The distance between the site of puncture and the lower edge of sacroiliac joint was ( 1.69 ± 0.63) cm.
穿刺层面距骶髂关节下缘（1.69±0.63）cm。 - Effects of different edge joint design on load carrying capability of canopy transparent materials have been studied in this paper.
研究了不同边缘连接设计对座舱透明件承载能力的影响。 - Measurement and Significance of Three-dimensional Center Edge Angle of Developmental Dislocation of Hip Joint in Children
儿童发育性髋关节脱位三维CE角的测量及其意义 - Based on nine experiments on edge joints of steel fiber concrete frame, the failure process and characteristics of the joints are studied, and the mechanism model of double shear-compression zone at joint core for shear capacity calculation is presented.
通过9个钢纤维混凝土框架边节点的试验，研究了此类节点的破坏过程与破坏特点，提出了节点核心区抗剪计算的双剪压受力机理模式。 - Development of Cut Edge Joint Belt
切边联组带的研制 - Mapping contours by edge structure and the way of dealing with joint relationship between contours and surface features
利用边结构绘制等高线及等高线和地物接合关系的处理方法 - Research on stress analysis and contacting edge effect for interference fit joint of hub
轴毂过盈联接的应力分析和接触边缘效应 - The Analysis of the Inner Edge of Instep Inboard Football Kicking Technology& On the Main Joint's Speed of the Kicking Leg
脚背内侧踢球技术特点与分析对脚背风侧踢定位球技术的生物力学研究&踢球腿主要关节运动速度的研究 - The edge stress at the joint of the elliptic heads and the cylinder is not calculated in the conventional design of medium and low pressure vessels. However, this edge stress greatly influences the manufacture and use of pressure vessel.
在中、低压力容器常规设计中，对椭圆封头与筒体连接处的边缘应力不做计算，但连接处的边缘应力对压力容器的制造和使用影响较大。 - Optical Wavelet Transform for Real-time Image Edge Extraction Based on Joint Transform Correlation
基于联合变换相关的光学小波实时图像边缘增强 - Whereas the Ordovician reservoirs were mainly formed in open platform facies, platform edge facies and algal beach facies, together with the joint influence by marine-burial diagenetic environments, the carbonate rocks were tightly cemented to form low-quality reservoir bed.
奥陶系储层主要形成于高水位体系域开阔台地相、台地边缘相和藻滩相中，由于受海水成岩和埋藏成岩环境影响，胶结作用发育，致使储层整体面貌呈Ⅳ类差储集层。 - Based on the characteristics of such weld pool images, the algorithm of image processing is designed. The whole edge of weld pool is extracted. The parameters of weld pool surface geometry are obtained under different TIG welding conditions of butt joint.
根据对接TIG焊熔池图像特点，设计出图像处理算法，检测出了焊接熔池的整个边缘，得到了不同工艺条件下对接TIG，焊熔池几何形状参数的实际尺寸。 - The double coupling electromagnetic sensor is used in this system to overcome the interference caused by the edge misalignment of but joint.
该系统采用电磁双重耦合电路克服工件错过造成的干扰。 - After that, we gave a mathematical formula and its computer program for JRC modified straight edge which contain scale effect of joint roughness coefficient.
考虑JRC的尺寸效应，推导JRC修正直边法的数学表达式，编译计算机常用程序。 - We can make use of the methods of image processing to deal with the picture, then determine the edge seat of overlap joint by the calculation method of connecting the deviation and depth value.
在对图像进行各种处理，如中值滤波、二值化、低高通滤波、细化等的基础上，给出搭接接头的边缘坐标确定方法以及纠偏量和深度值的计算方法。 - There was folding deformation on the edge of spot welding joint of domestic specimen.
国产板点焊试样焊点边缘产生了折叠变形； - An optical wavelet transform for real-time image edge extraction system based on joint transform correlation ( JTC) was proposed in this paper.
提出了一种基于联合变换相关的光学小波实时图像边缘增强的方法。 - Its pathological feature is destruction of articular cartilage and osteophyte formation on the edge of joint, that is degeneration of articular cartilage and succeeding bone hyperplasia.
其主要病变是关节软骨的破坏及关节边缘的骨赘形成，亦即关节软骨的退行性变和继发性骨质增生，一般认为与组织退变、长期劳损以及遗传、代谢等因素有关。 - Random variables will be multi-dimensional construct the joint distribution of independent and split the edge into the edge of the distribution of the estimates and the correlation between the distribution of structural analysis, making the question of the structure of the joint distribution easier and more accurate.
它将多维随机变量的联合分布构建问题独立地拆分成边缘分布的估计和边缘分布之间的相关结构分析，使得联合分布的构造问题更加容易也更加准确。 - Observe the changes in symptoms and signs recorded before and after treatment time of morning stiffness, double-hand edge, 10 meters walking, joint swelling, joint pain index, grade of joint function.
观察症状和体征的变化情况，记录治疗前后的晨僵时间、双手握力、10米步行时间，关节肿胀、关节疼痛指数、关节功能等级情况。